基于淀粉糊化机制低温合成了四方相BaTiO₃粉体。采用扫描电子显微镜、透射电子显微镜、X射线衍射、傅里叶变换红外光谱、紫外可见吸收光谱、X射线光电子能谱对合成粉体的形貌、物相进行表征；在超声条件下，以系列典型染料为降解对象测试BaTiO₃压电催化性能。结果显示，煅烧温度为600 ℃时即可获得四方相BaTiO₃粉体，且随着温度的提升，结晶度逐渐增加；当煅烧温度为700 ℃时，合成的BaTiO₃粉体尺寸分布均匀，分散度良好，呈现类立方体状；在超声驱动下，BaTiO₃降解罗丹明B、刚果红、甲基橙染料时均展现出良好的效果，反应速率常数分别为1.090×10^-2、1.113×10^-2、1.084×10^-2 min^-1，并以降解刚果红为对象揭示其压电催化的机理，即空穴和超氧自由基是降解过程中的主要反应物质。

采用原位聚合法制备了氯氧化铋(BiOCl)与聚苯胺(PANI)复合的Ⅱ型异质结光催化剂BiOCl/PANI，并采用X射线衍射(XRD)、傅里叶变换红外光谱(FTIR)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、紫外可见漫反射光谱(UV-Vis DRS)和N2吸附-脱附测试等多种技术手段对其进行了表征，考察了BiOCl/PANI在模拟可见光下对罗丹明B (RhB)的光催化降解性能。实验结果表明：BiOCl/PANI催化剂比PANI和BiOCl具有更高的光催化活性，在RhB质量浓度为50 mg·L^-1、PANI与BiOCl的物质的量之比为0.02∶1、50 mg·L^-1的催化剂条件下，所制备的BiOCl/PANI光催化150 min后，RhB降解率为98.8%，速率常数为0.031 min^-1；经过4次循环实验后，RhB降解率从98.8%降低至98.4%，表现出良好的稳定性和可重复利用性。光催化剂BiOCl/PANI实现了电子和空穴对的快速分离，降低了二者在催化剂内部的复合速率，提高了光催化性能。

利用碳空位缺陷有序化策略构筑了多层六方孔洞MXene电极材料，在软包超级电容器中实现了高比容量和高能量密度水系钾离子存储。该电极材料具有较大比表面积的三维六方孔洞结构，为储钾提供了更多的活性位点。结合六方孔洞内壁新暴露的钛原子的化合价变化引起的赝电容效应，阐明了多层六方孔洞MXene水系钾离子超级电容器比容量提高的内在原因。通过密度泛函理论计算多层六方孔洞MXene对钾离子的吸附能，并结合电化学储钾性能实验及动力学分析，确定了钾离子被吸附的最佳位置，得出了钾离子的吸附规律。通过定量分析多层六方孔洞MXene中电子的能带结构和差分电荷密度等电子传输规律，揭示了其水系钾离子超级电容器具有高电导率和良好倍率性能的内在机理。

仪器分析实验“分子荧光法测定罗丹明B的含量”存在实验过于简单、未考虑实际情况等问题。因此，本改进实验在三维荧光扫描模式下获取样本数据，不进行复杂预处理，而是运用化学计量学算法解析出目标分析物的纯信号，进而实现了染色辣椒中罗丹明6G和123的同时测定。本改进实验提高了学生全面考虑问题和创新解决问题的能力。

围绕以学生发展为中心的创新人才培养目标，我们在多年持续教改和探索基础上，提出了“综合+探究”式、模块化分析化学实验教学。要求学生在完成既定的综合实验基础上，针对实验过程中发现的问题，自主设计探究方案，进行个性化实验探究；同时，将研究生组会研讨模式融入到本科生实验教学中，增设方案答辩环节，实现“一生一方案”的教学。该教学方法实施以来，成效显著，不仅激发了学生学习兴趣和实验潜能，锻炼了实验思维和知识运用能力等综合实践能力，而且开启了对求异思辨、创新能力的培养，教学模式得到普遍欢迎和首肯。

A simple two-step hydrothermal method synthesized four different CdS/Fe₃O₄ photocatalysts with varying ratios of mass of CdS to Fe₃O₄. The composition and morphology of the prepared samples were investigated using X-ray diffraction (XRD), Raman spectrum, X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). Solid UV reflectance spectra testing found that CdS/Fe₃O₄ nanocomposites had good light absorption throughout the spectral range, promoting their photocatalytic properties. Under visible light irradiation, CdS/Fe₃O₄ (2:5) with a mass ratio of 2:5 exhibited excellent photocatalytic performance, with a degradation rate of 98.8% for rhodamine B. Furthermore, after five cycles of photocatalytic degradation reaction, the rhodamine B degradation rate remained at 96.2%, indicating that the photocatalysts have good photocatalytic stability.

A flower-like BiOBr photocatalyst (CS/BiOBr) was prepared by using the carbon material derived from corn straw (CS) as the carrier. The prepared composites were characterized by X - ray diffraction (XRD), Fourier transform infrared (FIIR) spectra, scanning electron microscope (SEM), X - ray photoelectron spectra (XPS), and UV-Vis diffuse reflectance spectra (UV-Vis DRS). The SEM analyses indicate that the introduction of CS promotes the formation of a unique flower-like structure in BiOBr, which not only optimizes the efficiency of light capture but also increases the specific surface area of BiOBr. The bandgap of the composite was narrower compared with the pure BiOBr. The CS/BiOBr composites exhibited higher photocatalytic activity than pure CS and BiOBr under visible light irradiation, and a higher first-order reaction rate constant (k) of 0.043 7 min^-1 than BiOBr (0.014 6 min^-1), and exhibited excellent stability and reusability during the cyclic run. The enhanced photocatalytic activity is attributed to the efficient separation of photoinduced electrons and holes. Superoxide radicals and holes were the major active species.