采用原位聚合法制备了氯氧化铋(BiOCl)与聚苯胺(PANI)复合的Ⅱ型异质结光催化剂BiOCl/PANI，并采用X射线衍射(XRD)、傅里叶变换红外光谱(FTIR)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、紫外可见漫反射光谱(UV-Vis DRS)和N2吸附-脱附测试等多种技术手段对其进行了表征，考察了BiOCl/PANI在模拟可见光下对罗丹明B (RhB)的光催化降解性能。实验结果表明：BiOCl/PANI催化剂比PANI和BiOCl具有更高的光催化活性，在RhB质量浓度为50 mg·L^-1、PANI与BiOCl的物质的量之比为0.02∶1、50 mg·L^-1的催化剂条件下，所制备的BiOCl/PANI光催化150 min后，RhB降解率为98.8%，速率常数为0.031 min^-1；经过4次循环实验后，RhB降解率从98.8%降低至98.4%，表现出良好的稳定性和可重复利用性。光催化剂BiOCl/PANI实现了电子和空穴对的快速分离，降低了二者在催化剂内部的复合速率，提高了光催化性能。

仪器分析实验“分子荧光法测定罗丹明B的含量”存在实验过于简单、未考虑实际情况等问题。因此，本改进实验在三维荧光扫描模式下获取样本数据，不进行复杂预处理，而是运用化学计量学算法解析出目标分析物的纯信号，进而实现了染色辣椒中罗丹明6G和123的同时测定。本改进实验提高了学生全面考虑问题和创新解决问题的能力。

A simple two-step hydrothermal method synthesized four different CdS/Fe₃O₄ photocatalysts with varying ratios of mass of CdS to Fe₃O₄. The composition and morphology of the prepared samples were investigated using X-ray diffraction (XRD), Raman spectrum, X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). Solid UV reflectance spectra testing found that CdS/Fe₃O₄ nanocomposites had good light absorption throughout the spectral range, promoting their photocatalytic properties. Under visible light irradiation, CdS/Fe₃O₄ (2:5) with a mass ratio of 2:5 exhibited excellent photocatalytic performance, with a degradation rate of 98.8% for rhodamine B. Furthermore, after five cycles of photocatalytic degradation reaction, the rhodamine B degradation rate remained at 96.2%, indicating that the photocatalysts have good photocatalytic stability.

A flower-like BiOBr photocatalyst (CS/BiOBr) was prepared by using the carbon material derived from corn straw (CS) as the carrier. The prepared composites were characterized by X - ray diffraction (XRD), Fourier transform infrared (FIIR) spectra, scanning electron microscope (SEM), X - ray photoelectron spectra (XPS), and UV-Vis diffuse reflectance spectra (UV-Vis DRS). The SEM analyses indicate that the introduction of CS promotes the formation of a unique flower-like structure in BiOBr, which not only optimizes the efficiency of light capture but also increases the specific surface area of BiOBr. The bandgap of the composite was narrower compared with the pure BiOBr. The CS/BiOBr composites exhibited higher photocatalytic activity than pure CS and BiOBr under visible light irradiation, and a higher first-order reaction rate constant (k) of 0.043 7 min^-1 than BiOBr (0.014 6 min^-1), and exhibited excellent stability and reusability during the cyclic run. The enhanced photocatalytic activity is attributed to the efficient separation of photoinduced electrons and holes. Superoxide radicals and holes were the major active species.

借用拟人化和第一人称的手法，以比赛中的主持人介绍和自我介绍的形式对10种不同的曾经或仍然具有其他用途的药物进行简要介绍。

为解决锂离子电池(LIBs)低温性能较差的问题，提出了一种通过调节电解质添加剂配方，提高电池低温性能的有效方法。其中，四氟硼酸锂(LiBF₄)+碳酸亚乙烯酯(VC)+1，3-丙烷磺酸内酯(PS)+氟代碳酸乙烯酯(FEC)的添加剂配方对电极有较好的保护作用，能够提高电化学性能。结果表明，目标电解液具有良好的低温性能，在-20和-40℃条件下电极的首圈放电比容量(0.2C)分别为144.65和133.05 mAh·g^-1，且具有良好的循环稳定性。研究表明，使用多功能添加剂可以显著提高锂离子的扩散速率，促进其在电极表面的释放。同时，添加剂较好的成膜性能还可以减少电池的极化，最终实现低温条件下高容量、高稳定的电池性能。

An efficient interlocking process was developed, including acid leaching, co-precipitation, and heat treatment, to regenerate waste LiNi_0.5Co_0.2Mn_0.3O₂ (NCM523) materials. DL-tartaric acid and formic acid were used as leaching systems, and the leaching efficiencies of Li, Ni, Co, and Mn reached about 98%. The leaching solution was added to the oxalic acid solution for a co-precipitation reaction, and then the regeneration of the material was realized through heat treatment. The regenerated NCM523 material exhibited an excellent layered structure and uniform elemental distribution. When employed as a cathode material for LIBs, the regenerated NCM523 exhibited a discharge-specific capacity of 168.5 mAh·g^-1 at 0.1C (18 mA·g^-1), which is comparable to the performance of fresh NCM523. Furthermore, the regenerated NCM523 demonstrated a capacity retention of 93.09% after 100 cycles at 0.5C.